Best Hunting Arrows for Your Bow: Calculator-Matched Spine Picks
Best arrows for compound-bow hunters selecting arrows from measured bow specifications
This list is for compound-bow hunters selecting arrows from measured bow specifications. You have put the bow on a scale, measured arrow length from the throat of the nock to the end of the insert, and chosen a point weight. Now you want a hunting multipack whose spine the maker’s chart actually gives for those numbers. Four things decide the picks. First, the shaft has to come in the spine the chart gives you, and most hunting setups land on 300, 340 or 400. Second, the dozen has to be consistent, which makers state as straightness in thousandths of an inch and weight tolerance in grains. Third, the finished arrow has to meet the bow maker’s minimum weight, commonly 5 grains per pound of draw weight, which is 350 grains for a 70 lb bow. Fourth, inserts, nocks and 8-32 screw-in points have to be easy to buy again.
Get bow scaleIf you want one answer, buy the Gold Tip Hunter XT. Gold Tip rates it at ±.003-inch straightness and ±2 grains per dozen on a .246-inch inside-diameter shaft. It comes as fletched six-packs with 2-inch Rapt-X vanes in 300, 340, 400 and 500 spines, and you read your size straight off Gold Tip’s own spine selector. It usually sells for about $65-75 per six-pack.
Get Gold Tip Hunter XTIf your chart says 250, or you size from Easton’s chart, buy the Easton 6.5mm Bowhunter. Easton lists it from a 250 spine at 10.0 grains per inch up to a 500 spine, and fletched six-packs usually sell for about $50.
Get Easton 6.5mm BowhunterIf you want a smaller .204-inch bore and more weight up front, buy the Victory RIP TKO. Victory lists spines from 200 to 400, 8.7 to 8.9 grains per inch in the 250 to 350 sizes, and includes a 50-grain stainless SHOK insert in the box.
Get Victory RIP TKOWe have not shot these arrows. The picks come from the makers’ spine charts and specification sheets and from what owners report.
Measure draw weight, arrow length and point weight before you open a chart
Every spine chart starts from three numbers. Two of them are often guessed, and a guess can move you a full spine size.
Draw weight, measured. If you have not weighed the bow, buy a bow scale first. Most compound limbs adjust over about 10 lb with the limb bolts, so a bow sold as “60-70 lb” can be set anywhere in that range. A bow backed out two turns per limb from peak no longer pulls its label weight. Hook the scale on the string at the nocking point, draw through the peak, and write down the highest reading, not the holding weight at the wall. That peak figure is the one the chart asks for.
Arrow length, measured the maker’s way. Gold Tip measures arrow length from the throat of the nock (where the string sits) to the end of the insert, not to the tip of the point. This is not your draw length. A hunter with a 29-inch draw might cut arrows at 28 inches so the broadhead sits clear of the rest and the bow hand at full draw. Use the cut length in the chart. Easton’s chart rounds fractions by a stated rule: 28.25 inches goes in the 28-inch column, and 28.5 inches goes up to the 29-inch column.
Point weight. Charts are built around a 100-grain point. Gold Tip prints separate columns for 100, 125 and 150 grains. If you shoot a 125-grain broadhead, practise with 125-grain field points and read the 125 column.
What the spine number means. Easton prints spine as deflection in inches over a 28-inch span. In the industry test (ASTM F2031), a 1.94 lb weight hangs from the middle of the shaft. A 400 shaft bends 0.400 inch and a 300 shaft bends 0.300 inch, so the lower number is stiffer. A shorter cut, a lighter point or a lower draw weight all make an arrow act stiffer, and their opposites make it act weaker.
Reading the spine chart: worked examples and what moves you a size
On a typical compound chart for 300-340 fps bows and 100-grain points, three common setups read like this:
- 50 lb, 28-inch arrow, 100 grains: 400 spine.
- 60 lb, 29-inch arrow, 100 grains: 340 spine. The extra inch makes the shaft act weaker, so the chart moves stiffer than it would at 28 inches.
- 70 lb, 28-inch arrow, 100 grains: 300 spine on most charts.
These are starting points. Each maker writes its own assumptions into the chart, and those assumptions decide whether your bow fits the printed column.
Bow speed rating. Easton’s hunting chart assumes a bow rated at 301-340 fps ATA, screw-in 100-grain points and a release aid. Gold Tip prints a separate compound table for bows rated above 315 fps IBO. Victory’s charts are printed for 300-340 fps bows. A faster cam loads the shaft harder than its draw weight suggests, so a bow rated above the chart’s band acts like a heavier bow. Read the column for the next draw weight up.
Point weight. Going from 100 to 125 grains makes the arrow act weaker. If your 100-grain result sits near the edge of a spine band, the 125-grain column can push you one size stiffer.
Between two sizes, take the stiffer one. A fixed-blade broadhead has steering surface at the front, and a weak shaft lets it pull the arrow away from your field-point group. A slightly stiff shaft usually tunes out with rest and nocking-point adjustment. A weak one often needs a lighter head or a shorter cut.
Do not convert between brands. Gold Tip and Easton sell 340 spines. Victory’s RIP TKO line sizes 300, 350 and 400. A Gold Tip 340 result does not mean “buy the Victory 350.” Read Victory’s own chart for the RIP TKO and buy the size it gives.
Gold Tip Hunter XT: the top pick for most hunting bows
The Hunter XT wins for most hunters because it combines tight tolerances, the common spine sizes and a standard bore. Gold Tip lists ±.003-inch straightness and ±2 grains weight tolerance per dozen. Those are the two figures that decide whether arrow number eleven lands with arrow number one. The .246-inch inside diameter is the most common hunting bore, so inserts, outserts, nocks and 8-32 screw-in field points and broadheads are easy to find. A replacement half-dozen comes in the same 300, 340, 400 or 500 spine you started with.
It meets the four demands like this. Spine coverage runs from 300 for 65-70 lb bows to 500 for light-draw and short-draw setups. Consistency is stated in thousandths of an inch and in grains. Weight sits in the middle, neither an ultralight speed shaft nor a heavy penetration build. Paired with a 100- or 125-grain head, it clears the 5-grains-per-pound minimum on most bows up to 70 lb. Fletched six-packs come with 2-inch Rapt-X vanes, which are short enough to clear a drop-away rest and give enough steering for fixed-blade heads.
Gold Tip also makes a lower tier, the Hunter, on the same .246-inch shaft with the same 300 to 500 sizes and ±2 grains per dozen, but Gold Tip rates it at ±.006-inch straightness. It usually sells for about $55 per six-pack. It makes sense as a backyard practice dozen. For the arrows that go in the quiver on opening day, the XT’s tighter straightness is the better buy.
Who should not buy the Hunter XT: anyone whose chart result is 250. Gold Tip sells the XT six-packs in 300 to 500, so the Easton below is the better fit for very heavy or very long-draw setups. Bowhunters building a heavy, high-FOC elk arrow should also look elsewhere, because they usually want a smaller bore with a heavy insert, which is the Victory pick.
Easton 6.5mm Bowhunter: for 250-spine results and Easton-chart builds
The Easton 6.5mm Bowhunter is the pick when your chart result is stiffer than 300, or when you size from Easton’s chart and want the shaft that chart was written for. Easton lists it in 250, 300, 340, 400 and 500 spines. The 250 size is rated at 10.0 grains per inch, so it adds mass for a heavy-draw, long-arrow setup. A 30-inch 250 shaft carries 300 grains before the insert, nock, vanes and point go on.
The 6.5mm bore is Easton’s version of the standard hunting diameter. Easton’s 6.5mm line uses its own 6.5mm inserts and nocks, so buy those components rather than assuming another brand’s .246 inserts fit. The point thread is the common 8-32, so screw-in field points and broadheads from the major makers fit once the Easton insert is installed.
The trade-off is consistency. The Bowhunter is the looser-tolerance entry in Easton’s 6.5mm family. Easton rates the Hunter Classic at ±.003 inch and the Match Grade at ±.001 inch, at higher prices. At typical whitetail distances inside 40 yards, the Bowhunter’s tolerance is the reason it costs about $50 per fletched six-pack, and owners mostly report it groups well with field points once spine and length are right.
Who should not buy it: a hunter whose Gold Tip result is 340 or 400 and who only wants one brand’s chart to follow. The Hunter XT covers those sizes with tighter stated straightness. Also skip it if you shoot 50 or 60 yards on western hunts and want every shaft within ±.003 inch. Spend the extra on Easton’s Hunter Classic instead.
Victory RIP TKO: small diameter and a heavier front end
The Victory RIP TKO suits hunters who want a smaller-diameter arrow for crosswinds and penetration on elk-sized game. It has a .204-inch inside diameter, about .266-inch outside diameter in the listed sizes, and Victory sizes it 200, 250, 300, 350 and 400. Shaft weight is 8.9 grains per inch at 250, 8.8 at 300 and 8.7 at 350. The box includes a 50-grain stainless SHOK insert and a 9-grain nock.
That insert changes the arithmetic. A 28-inch RIP TKO 300 shaft weighs about 246 grains (28 × 8.8). Add the 50-grain insert, the 9-grain nock and a 100-grain broadhead, and the arrow reaches about 405 grains before vanes. That is well over the 350-grain minimum for a 70 lb bow, and most of the added weight sits at the front, which raises front-of-center balance. If you want a lighter, faster arrow for a 60 lb bow, this is the wrong shaft.
Victory sells the RIP TKO in three grades with different straightness: Elite at ±.001 inch, Gamer at ±.003 inch and Sport at ±.006 inch. The Elite listing also states weight matching to ±0.5 grains per dozen. For hunting, the Gamer grade matches the Hunter XT’s straightness. The Elite grade is mainly worth it when you shoot long distances in open country.
Size it from Victory’s own chart, which covers the RIP TKO and is printed for 300-340 fps bows. Do not translate a 340 result from another brand into a 350. Who should not buy it: hunters with an existing stock of .246 inserts, outserts and broadhead adapters. The .204 bore takes its own components, and nothing from a Hunter XT build carries over.
What is not worth the money, and the mistakes that waste a dozen
Universal-spine multipacks. Generic 12-packs that list one spine against a draw range as wide as 30 to 80 lb cannot be right for that whole range. On the charts above, a 28-inch arrow moves from 500 at light draw weights to 300 near 70 lb. If a listing does not say which draw weight and length its spine matches, do not use it for broadheads.
Match-grade straightness for treestand distances. Shafts rated at ±.001 inch cost much more than ±.003 inch. Inside 30 yards on whitetails, that difference is smaller than the error from a weak spine or a crooked broadhead. Spend the money on getting the spine and length right first.
Cutting without re-reading the chart. Every inch you cut makes the shaft act stiffer. Ordering for a 29-inch arrow and then cutting to 27.5 inches can put you a full size off. Settle the cut length before you buy, and check that the chart result still holds at that length.
Mixing point weights. Practising with 100-grain field points and hunting with 125-grain broadheads changes both the dynamic spine and the arrow’s point of impact. Match the field point weight to the broadhead weight, and read the chart column for that weight.
Skipping the inspection after a hit. Flex every carbon shaft you shoot into a target or bone, and listen for cracking. Retire any arrow that clicks or shows a split near the insert. A fractured shaft can fail on the string. Spin each broadhead-tipped arrow on its point, and replace an insert or head that wobbles before the arrow goes back in the quiver.
Related guides
- Adjustable Youth and Beginner Compound Bows: Choosing by Draw Length and Draw Weight Range
- Archery Targets for Bowhunting Practice (bag, foam block, 3D animal, broadhead-rated, and replacement cores/covers)
- Arrow Inserts, Nocks and Outserts: Matching Components to Your Shaft
- Bow Cases for Bowhunting: Hard vs Soft vs Hybrid Compound Bow Cases for Truck Travel, Airline Flights and ATV/Backcountry Transport
- How to Match Arrow Spine to Your Hunting Bow
- Choosing the Right Broadhead Grain Weight for Your Setup
FAQ
What spine arrow do I need for a 70 lb compound bow?
With a 28-inch arrow and a 100-grain point, most compound charts give a 300 spine for a 70 lb bow. A longer arrow, a heavier point or a bow rated above the chart’s speed band can push you to 250. Read the maker’s chart for the shaft you are buying, and use your measured peak draw weight, not the number on the limb.
Is arrow length the same as draw length?
No. Gold Tip measures arrow length from the throat of the nock to the end of the insert, and that cut length is what the spine chart uses. Many hunters cut their arrows shorter than their draw length, as long as the broadhead stays clear of the rest and the bow hand at full draw.
Can I use a Gold Tip spine chart result to buy Victory or Easton arrows?
Use each maker’s own chart. Gold Tip and Easton sell 340 spines, while Victory sizes the RIP TKO at 300, 350 and 400. Each chart assumes its own bow speed band and components. Victory also includes a 50-grain insert, which changes how the arrow flexes.